How to Crimp a Perfume Sprayer onto a 15 mm Bottle
Share
Most full-size perfume bottles, including our 50 ml and 100 ml flacons, use a crimp-on sprayer: a metal pump that is pressed permanently onto the neck of the bottle. Crimping gives you a clean, leak-proof seal that looks like a finished retail product. It takes a minute per bottle once you have the hang of it.
What you need
- A filled 15 mm crimp-neck bottle, such as The Dusk, The Orb or The Onyx & Ember
- A 15 mm crimp-on spray pump with a dip tube (our bottles include one; spares come in packs of five)
- A crimper with a 15 mm head, such as our pocket manual crimper
- Scissors and a paper towel
Step 1: Fill the bottle, leaving headspace
Fill the bottle with a small funnel or pipette, stopping a little below the neck. The pump and dip tube take up space when they go in, so a completely full bottle will overflow and leave fragrance on the neck, which can stop the crimp from sealing. Wipe the neck dry before you go on.
Step 2: Trim the dip tube
Hold the pump against the outside of the bottle with its collar level with the neck. The dip tube should reach almost to the bottom of the bottle. Cut it with scissors so the tip sits just above the base; an angled cut helps it draw up the last of the liquid. If the tube is too long it curls and can block; if it is too short, the last few millilitres will be left behind.
Step 3: Seat the pump on the neck
Lower the dip tube into the bottle and set the pump's metal collar squarely on the neck. Make sure it sits flat and centred, not tilted. A crooked pump will crimp unevenly and may leak.
Step 4: Crimp
Place the 15 mm side of the crimper over the collar so the jaws surround it evenly. Squeeze the handles firmly and steadily until they stop. The jaws fold the bottom of the collar under the lip of the neck all the way round. Release and look at the collar from every side: it should be tight and even, with no gaps.
Step 5: Fit the cap and test
Press on the cap, then take it off and give a few test sprays into the air until the fragrance comes through. Turn the bottle upside down over a paper towel for a few seconds. If no liquid appears at the collar, the seal is good.
Common problems
- Leaking at the collar: the pump was tilted, or the neck was wet when crimped. Unfortunately a crimped pump cannot be removed and re-used, so take care with seating and drying.
- Weak or no spray: the dip tube is too short or kinked, or the pump needs a few more primes.
- Collar spins on the neck: the crimp was not pressed all the way. Squeeze again, firmly, until the handles stop.
Don't want to crimp?
Our 10 ml and 15 ml sprays, The Pocket and The Courier, have screw-on atomizers, so no crimper is needed and they can be refilled again and again.
Have a question about a bottle or a bigger run? Get in touch.